2004 Honda Vtx1300 Recalls

No recalls on record Updated July 2026

No NHTSA recalls on record for the 2004 Honda Vtx1300. That means NHTSA has no open safety campaign for this vehicle — it does not guarantee the absence of problems. Owners have filed 90 complaints with NHTSA, most often about the steering. Last updated July 5, 2026.

Complaints by component

STEERING
24
1injuries
SUSPENSION
13
1injuries
SUSPENSION:FRONT
10
STEERING: STEERING WHEEL/HANDLE BAR
9
1crashes
VEHICLE SPEED CONTROL
9
ELECTRICAL SYSTEM
3
POWER TRAIN:DRIVELINE
3
UNKNOWN OR OTHER
3
WHEELS
3
1crashes1injuries
FUEL SYSTEM, GASOLINE
2
Total complaints90

What owners report

Verbatim reports filed with NHTSA, lightly edited for readability and with personal information removed.

“The contact owns a 2004 honda vtx1300. The contact stated that while the motorcycle was parked, a fuel-like odor was detected in the garage. The contact then noticed fuel leaking from the motorcycle, with no warning lights illuminated. The dealer was contacted. The motorcycle was not diagnosed or…”

FUEL SYSTEM, GASOLINE · reported 2026-05-26

“There is a severe front end wobble when decelerating from 50+ mph. The entire front end shakes to the point that control is almost lost. It is also causing the tire on the front to wear unevenly and at a very fast rate. The bike has less than 6000 miles on it as of march of 2018.”

SUSPENSION · reported 2018-01-24

“On 2004 honda vtx1300c motorcycle, front tire develops a severe shimmy when decelerating from 40-50 mph. Have reported problem to honda repair center and tech's state they do not know cause of problem where many forums one stated to replace front wheel bearings with vtx 1800 tapered bearings.”

STEERING · reported 2016-03-01

“My front end wobbles bad when I'm slowing down. It happens on both city streets and highways.I replaced the front and back tires and had them balanced. Nothing changed. I've researched it and it's apparently a common problem with the 1300 models and replacing the upper and lower steering bearings…”

STEERING · reported 2015-06-06

“Removed the front and rear wheels to have new tires installed. Noticed the final drive flange bearings seal toward wheel, was torn open as if the seal had melted and the bearings were dry and very rough to turn. Problem is, I replaced the bearings and felt resistance when turning the new bearings.…”

SUSPENSION · reported 2014-06-02

“Removed the front and rear wheels to have new tires installed. Noticed the final drive flange bearings seal toward wheel, was torn open as if the seal had melted and the bearings were dry and very rough to turn. Problem is, I replaced the bearings and felt resistance when turning the new bearings.…”

POWER TRAIN · reported 2014-06-02

“This part is mounted to the rim of the motorcycle and connects to the drive shaft . The housing that the flange bearings press into is bored to tight causing the bearings to be crushed and not be smooth like they should be . I purchased brand new bearings and had the dealer put them in having the…”

WHEELS · reported 2012-03-30

“Just purchased this bike I'm 2nd owner, and while inspecting this bike I noticed that left side of front tire was completely worn but right side had tread, so I replaced with new dunlop tires front and rear and after driving having only 300 miles on bike one day I let go of left hand grip at 40…”

STEERING · reported 2011-09-02
Sources & methodology

Recall, complaint, and investigation records from official NHTSA datasets (FLAT_RCL, FLAT_CMPL, FLAT_INV), synced weekly. Counts reflect NHTSA records for the 2004 Honda Vtx1300 as of July 5, 2026. Complaint narratives are consumer-submitted and unverified. This page contains ads and affiliate links. Full methodology.