How many recalls does the 2003 Peterbilt 330 have?

The 2003 Peterbilt 330 has 3 NHTSA safety recall campaigns on record.

How do I check if my 2003 Peterbilt 330 has an open recall?

Enter your 17-character VIN at NHTSA's official recall lookup (nhtsa.gov/recalls) to see open, unrepaired recalls for your specific vehicle. Recall repairs are free.

2003 Peterbilt 330 Recalls

Recalls on record Updated July 2026

The 2003 Peterbilt 330 has 3 NHTSA recall campaigns affecting an estimated 3,177 vehicles. Recall repairs are always free at any authorized dealer. Last updated July 5, 2026.

Recall campaigns

STEERING 03V410000 2003-10-20 1,187 affected

Defect

ON CERTAIN TRUCKS EQUIPPED WITH DANA SPICER INTEGRAL KNUCKLE AND STEER ARM ASSEMBLIES, THE STEER AXLE ASSEMBLIES MAY HAVE A LONGITUDINAL CRACK IN THE STEER ARM.

Consequence

IF THE CRACK SHOULD PROPAGATE OVER TIME, THE BALL COULD BECOME LOOSE RESULTING IN A LOSS OF STEERING, WHICH COULD RESULT IN A CRASH.

Remedy

DEALERS WILL INSPECT AND REPLACE THE KNUCKLE AND STEER ARM ASSEMBLIES. OWNER NOTIFICATION BEGAN JANUARY 5, 2004. OWNERS SHOULD CONTACT KENWORTH AT 1-425-828-5440 OR PETERBILT AT 1-940-591-4201.

ENGINE AND ENGINE COOLING 03V306000 2003-08-22 1,858 affected

Defect

ON CERTAIN TRUCKS EQUIPPED WITH CATERPILLAR C7 OR 3126E 2002 ENGINES AND HORTON FAN HUBS, THE FAN HUB MOUNTING BOLTS CAN FAIL RESULTING IN THE HUB AND FAN ASSEMBLY SEPARATING FROM THE ENGINE. THIS LOSS OF CLAMP LOAD CAUSES UNWANTED VIBRATION IN THE ASSEMBLY THAT LEADS TO BOLT FAILURE.

Consequence

IF THE BOLTS FAIL, THE COMPLETE HUB AND FAN ASSEMBLY COULD SEPARATE FROM THE ENGINE RESULTING IN EQUIPMENT DAMAGE AND/OR PERSONAL INJURY.

Remedy

DEALERS WILL ADD A RIGID SPACER ACROSS THE TWO LOWER MOUNTING HOLES OF THE FAN HUB TO MAINTAIN THE CLAMPING FORCE AND REPLACE ALL THE BOLTS AND WASHERS. OWNER NOTIFICATION BEGAN OCTOBER 22, 2003. OWNERS SHOULD CONTACT PETERBILT AT 1-940-591-4201.

POWER TRAIN 03V288000 2003-08-06 132 affected

Defect

ON CERTAIN HEAVY DUTY TRUCKS, THE LOCKING TAB THAT LOCKS THE OUTER SPINDLE NUT ONTO THE SPINDLE WAS NOT ENGAGED OR PROPERLY BENT OVER.

Consequence

FAILURE TO PROPERLY ENGAGE THE LOCKING FEATURE INTO THE NUT COULD CAUSE THE NUT TO LOOSEN WHICH WILL EVENTUALLY CAUSE THE WHEEL BEARING TO OVER HEAT AND FAIL IF UNDETECTED. IF THE LOOSE NUT IS NOT DETECTED, THE OUTER END (TIRE, WHEEL AND HUB ASSEMBLY) COULD BECOME SEPARATED FROM THE VEHICLE, INCREASING THE RISK OF A…

Remedy

DEALERS WILL INSPECT THE HUBS TO DETERMINE IF THE LOCKING TABS ARE PROPERLY BENT. IF THE LOCKING TABS ARE NOT BENT, THEN DEALERS WILL INSPECT THE APPROPRIATE COMPONENTS FOR PREMATURE WEAR AND REPLACE SUCH COMPONENTS AS REQUIRED AND PROPERLY SECURE THE RETAINING NUT BY BENDING OVER THE LOCKING TAB. OWNER…

Sources & methodology

Recall, complaint, and investigation records from official NHTSA datasets (FLAT_RCL, FLAT_CMPL, FLAT_INV), synced weekly. Counts reflect NHTSA records for the 2003 Peterbilt 330 as of July 5, 2026. Complaint narratives are consumer-submitted and unverified. This page contains ads and affiliate links. Full methodology.